剛取得一台 "ASUS WL-HDD2.5", 昨天已經先做了功課, 知道可以改刷OpenWRT 或oleg, 檢視了一下ASUS 原廠韌體所提供的功能, 乏善可陳, 決定還是改刷oleg v1.9.2.7-9, 在繼續之前, 先以 "fping" 瞭解一下重新啟動的反應, 由於OpenWRT 已經確定WL-HDD "boot_wait" 為On, 所以tftp 應該可行, 只是不確定PMON 會暫停多久, 根據 "fping" 的結果, 至少有1 秒, 小弟刷機已經很有經驗了, 不打算採用華碩的 "救援模式", 而且也想測試一下上回寫的自動更新批次檔是否堪用, 所以回頭參考 "【韌體】貝爾金 Belkin F5D7230-4 v1444 韌體更新", 首先關閉 "Windows TCP/IP Media Sensing", 再將網卡調整為 "10Mbps/Full Duplex", 重新啟動Windows 讓設定生效, 接著執行 "FW_Upg.bat 192.168.1.220 WLHDD-1.9.2.7-9.trx", 一試成功, 結果如下:
C:\>fw_upg.bat 192.168.1.220 WLHDD-1.9.2.7-9.trx
Router Firmware Auto TFTP Upgrade Procedure for Windows v1.0
==============================================================
Syntax: fw_upg [host_ip] [firmware]
--------------------------------------------------------------
a) Login to Web GUI of the router before running this batch.
b) Press any key from this window to start pinging the router.
c) Select "Reboot" from Web GUI of the router.
d) Do Not power cycle the router during this procedure.
--------------------------------------------------------------
Requirements: Fping from http://www.kwakkelflap.com/fping.html
--------------------------------------------------------------
Copyleft: FYI@PCZONE
=====================
.
Press Ctrl-C at anytime to stop.
請按任意鍵繼續 . . .
19:09:56 : Reply[1] from 192.168.1.220: bytes=32 time=1.5 ms TTL=64
... (恕刪)
19:10:04 : Reply[1] from 192.168.1.220: bytes=32 time=1.5 ms TTL=64
19:10:06 : 192.168.1.220: request timed out
19:10:06 : 192.168.1.220: request timed out
19:10:06 : 192.168.1.220: request timed out
19:10:06 : 192.168.1.220: request timed out
19:10:06 : 192.168.1.220: request timed out
19:10:06 : 192.168.1.220: request timed out
19:10:07 : 192.168.1.220: request timed out
19:10:07 : 192.168.1.220: request timed out
19:10:07 : 192.168.1.220: request timed out
19:10:07 : 192.168.1.220: request timed out
19:10:07 : 192.168.1.220: request timed out
19:10:07 : 192.168.1.220: request timed out
19:10:07 : 192.168.1.220: request timed out
19:10:08 : Reply[1] from 192.168.1.220: bytes=32 time=1.2 ms TTL=128
*****************************
Start TFTP. Do not interrupt.
*****************************
C:\>tftp -i 192.168.1.220 PUT WLHDD-1.9.2.7-9.trx
Transfer successful: 3780608 bytes in 6 seconds, 630101 bytes/s
.
Finished. Please reload the "New" Web GUI.
刷機前後, 皆不需關機, 刷機之後, 請等候數分鐘, 便可登入WebGUI
之前忘了說明操作步驟, 請先恢復WL-HDD 出廠設定, 並保持正常啟動狀態, 然後執行 "FW_Upg.bat", 再由ASUS WebGUI 隨便找個畫面, 按下 "Finish", 選 "Save & Reboot", 接著就是自動偵測自動更新, 更新成功後WL-HDD's IP 不變, 仍為 "192.168.1.220", 帳號密碼改為 "空白/admin", 但執行 "Factory Default" 之後, IP 變成 "192.168.1.1", 預設帳號密碼為 "admin/admin", 若設定過程意外導致無法登入, 則於正常啟動之後, 等候數分鐘, 再按住Reset 30 秒以上, 即可恢復預設值(ASUS 或oleg)
ASUS WL-HDD R1.15 硬體資訊:
CPU: Broadcom BCM4702KPB @ 125MHz
Flash: 4MB
RAM: 16MB
USB1.1 x 1 (可DIY 第二組)
IDE-Controller: PROMISE PDC20265R
Wireless: Broadcom BCM4306KFB 802.11b/g
Ethernet: Realtek RTL8201CP 10/100M x 1
預設IP 為 "192.168.1.220" 或 "192.168.1.1"
預設帳號密碼為 "admin/admin" 或 "空白/admin"
華碩 ASUS WL-520g 韌體更新
書籤