原廠的和新版的openwrt都不行
(檔案大小關係? erase cp.b範圍要改?)
openwrt-ar71xx-mzk-m04nu-squashfs-factory.bin 7680kb
mzkw04nu_v10323.bin 7680kb
後來我抓舊的的Backfire 10.03 Released
openwrt-ar71xx-mzk-w04nu-squashfs.bin 7616kb
reset後就通過
U-Boot 1.1.4 (Oct 25 2007 - 15:28:59)
AP81 (ar7100) U-boot
DRAM:
sri
32 MB
Top of RAM usable for U-Boot at: 82000000
Reserving 222k for U-Boot at: 81fc8000
Reserving 192k for malloc() at: 81f98000
Reserving 44 Bytes for Board Info at: 81f97fd4
Reserving 36 Bytes for Global Data at: 81f97fb0
Reserving 128k for boot params() at: 81f77fb0
Stack Pointer at: 81f77f98
Now running in RAM - U-Boot at: 81fc8000
id read 0x100000ff
flash size 8MB, sector count = 128
Flash: 8 MB
*** Warning - bad CRC, using default environment
In: serial
Out: serial
Err: serial
Net: ag7100_enet_initialize...
Fetching MAC Address from 0x81fedb10
eth0: 00:22:cf:04:df:57
dup 1 speed 100
eth0 up
eth0
====check reset button function====
### main_loop entered: bootdelay=4
### main_loop: bootcmd="bootm 0xbf050000"
Hit any key to stop autoboot: 0
## Booting image at bf050000 ...
Image Name: MIPS OpenWrt Linux-2.6.32.10
Created: 2010-04-06 13:03:06 UTC
Image Type: MIPS Linux Kernel Image (gzip compressed)
Data Size: 1227490 Bytes = 1.2 MB
Load Address: 80060000
Entry Point: 80060000
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK
No initrd
## Transferring control to Linux (at address 80060000) ...
## Giving linux memsize in bytes, 33554432
Starting kernel ...
Linux version 2.6.32.10 (
[email protected]) (gcc version 4.3.3 (GCC) ) #20 Tue Apr 6 15:01:26 CEST 2010
bootconsole [early0] enabled
CPU revision is: 00019374 (MIPS 24Kc)
Atheros AR9132 rev 1, CPU:400.000 MHz, AHB:200.000 MHz, DDR:400.000 MHz
Determined physical RAM map:
memory: 02000000 @ 00000000 (usable)
Initrd not found or empty - disabling initrd
Zone PFN ranges:
Normal 0x00000000 -> 0x00002000
Movable zone start PFN for each node
early_node_map[1] active PFN ranges
0: 0x00000000 -> 0x00002000
Built 1 zonelists in Zone order, mobility grouping on. Total pages: 8128
Kernel command line: rootfstype=squashfs,yaffs,jffs2 noinitrd console=ttyS0,115200 board=MZK-W04NU
PID hash table entries: 128 (order: -3, 512 bytes)
Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes
Writing ErrCtl register=00000000
Readback ErrCtl register=00000000
Memory: 29332k/32768k available (2101k kernel code, 3436k reserved, 397k data, 152k init, 0k highmem)
SLUB: Genslabs=7, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
Hierarchical RCU implementation.
NR_IRQS:56
Calibrating delay loop... 266.24 BogoMIPS (lpj=1331200)
Mount-cache hash table entries: 512
NET: Registered protocol family 16
MIPS: machine is Planex MZK-W04NU
bio: create slab <bio-0> at 0
Switching to clocksource MIPS
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 1024 (order: 1, 8192 bytes)
TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
TCP: Hash tables configured (established 1024 bind 1024)
TCP reno registered
NET: Registered protocol family 1
squashfs: version 4.0 (2009/01/31) Phillip Lougher
Registering mini_fo version $Id$
JFFS2 version 2.2. (NAND) (SUMMARY) © 2001-2006 Red Hat, Inc.
yaffs Mar 28 2010 17:53:41 Installing.
msgmni has been set to 57
io scheduler noop registered
io scheduler deadline registered (default)
Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled
serial8250.0: ttyS0 at MMIO 0x18020000 (irq = 11) is a 16550A
console [ttyS0] enabled, bootconsole disabled
console [ttyS0] enabled, bootconsole disabled
Atheros AR71xx SPI Controller driver version 0.2.4
m25p80 spi0.0: m25p64 (8192 Kbytes)
Searching for RedBoot partition table in spi0.0 at offset 0x7e0000
Searching for RedBoot partition table in spi0.0 at offset 0x7f0000
No RedBoot partition table detected in spi0.0
spi0.0: no WRT160NL signature found
Creating 6 MTD partitions on "spi0.0":
0x000000000000-0x000000040000 : "u-boot"
0x000000040000-0x000000050000 : "u-boot-env"
0x000000050000-0x0000001b0000 : "kernel"
0x0000001b0000-0x0000007e0000 : "rootfs"
mtd: partition "rootfs" set to be root filesystem
mtd: partition "rootfs_data" created automatically, ofs=2F0000, len=4F0000
0x0000002f0000-0x0000007e0000 : "rootfs_data"
0x0000007e0000-0x000000800000 : "art"
0x000000050000-0x0000007c0000 : "firmware"
ag71xx_mdio: probed
eth0: Atheros AG71xx at 0xb9000000, irq 4
eth1: Atheros AG71xx at 0xba000000, irq 5
Atheros AR71xx hardware watchdog driver version 0.1.0
TCP westwood registered
NET: Registered protocol family 17
802.1Q VLAN Support v1.8 Ben Greear <
[email protected]>
All bugs added by David S. Miller <
[email protected]>
VFS: Mounted root (squashfs filesystem) readonly on device 31:3.
Freeing unused kernel memory: 152k freed
Please be patient, while OpenWrt loads ...
gpio-buttons driver version 0.1.2
input: gpio-buttons as /devices/platform/gpio-buttons/input/input0
Button Hotplug driver version 0.3.1
eth0: link up (100Mbps/Full duplex)
- preinit -
Registered led device: mzk-w04nu:green:status
Registered led device: mzk-w04nu:blue:wps
Registered led device: mzk-w04nu:green:wlan
Registered led device: mzk-w04nu:green:usb
Registered led device: mzk-w04nu:green:ap
Registered led device: mzk-w04nu:green:router
Press the [f] key and hit [enter] to enter failsafe mode
- regular preinit -
switching to jffs2
mini_fo: using base directory: /
mini_fo: using storage directory: /overlay
- init -
eth0: link down
Please press Enter to activate this console. eth0: link up (100Mbps/Full duplex)
device eth0 entered promiscuous mode
br-lan: port 1(eth0) entering forwarding state
PPP generic driver version 2.4.2
ip_tables: (C) 2000-2006 Netfilter Core Team
NET: Registered protocol family 24
nf_conntrack version 0.5.0 (460 buckets, 1840 max)
CONFIG_NF_CT_ACCT is deprecated and will be removed soon. Please use
nf_conntrack.acct=1 kernel parameter, acct=1 nf_conntrack module option or
sysctl net.netfilter.nf_conntrack_acct=1 to enable it.
eth1: link up (100Mbps/Full duplex)
現在還是ping 不到機器 telnet也無法.....
等下試試看Please press Enter to activate this console.