|
【問題】cissco router one physical port 分兩個VLAN 贊助商連結 頁 :
1
[2]
Lettuce 2006-06-23, 05:24 PM Secondary IP (http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124tcr/tiad_r/adressht.htm#wp1135431) IEEE 802.1Q Frame Format (http://www.cisco.com/en/US/tech/tk389/tk390/technologies_tech_note09186a0080094665.shtml#topic2) 贊助商連結 yangac 2006-06-23, 06:55 PM Secondary IP (http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124tcr/tiad_r/adressht.htm#wp1135431) IEEE 802.1Q Frame Format (http://www.cisco.com/en/US/tech/tk389/tk390/technologies_tech_note09186a0080094665.shtml#topic2) 我用另一台pc 當 192.168.9.2 但不設default route，仍然不通。 如果我用secondary IP，應該就不受Format 的限制了吧?!再試一下!! 謝謝 yangac 2006-06-26, 08:48 PM 我用另一台pc 當 192.168.9.2 但不設default route，仍然不通。 如果我用secondary IP，應該就不受Format 的限制了吧?!再試一下!! 謝謝 我試了Secondary IP, 用Router 可以ping 到 192.168.4.2 and 192.168.9.2 而且可以在Router上 ping到Internet's any hosts. 可是, 192.168.4.x的電腦不能ping 192.168.9.2 (Which is the Gateway to Internet) 我已經用IP routing. 有沒有人知道要如何Route Traffic? 謝謝 thomasc 2006-06-28, 11:37 AM 192.168.4.0的routing怎麼跑? yangac 2006-06-29, 01:03 AM 192.168.4.0的routing怎麼跑? The subnet go to the internet through the router via 192.168.9.x Lettuce 2006-06-29, 05:22 PM 麻煩把下列兩項info貼出來... show run show ip route 方便的話.請連同 show version 記得把username跟password的部份上馬賽克 yangac 2006-06-29, 10:21 PM 麻煩把下列兩項info貼出來... show run show ip route 方便的話.請連同 show version 記得把username跟password的部份上馬賽克 請看圖片, Thanks a lot! http://www.pixpond.com/1/hnr83.JPG http://www.pixpond.com/1/hnr834.JPG http://www.pixpond.com/1/4wlkxn.JPG yangac 2006-06-30, 04:34 AM I already solve the problem. The reason is because of the bad router. I connect to TAC for Cisco technical support to assist me to reset the router, and then the network is worked. So, the conclusion is if you don't have the VLAN Switch, you can use the sendary IP of a router to route your traffic in different subnets. Thank you all. |
|
|