范靜善
2001-11-13, 12:31 PM
請問各位大大,我做完fdisk之後,(不割硬碟,只做一個主硬碟)
(步驟是先按[y] , 1->1 , [y] )
用a:重新開機要準備format時,卻出現
Windows98 has detected that drive c does not contain a vaild
Fat or FAT32 partiton.There are several possible causes.
1.The drive may need to be partitioned. To create a partition on
the drive,run fdisk from the MS-DOS command prompt.
2.you may using third-parth disk-partitioning software.If you are using
this type of software, remove the Emergency Boot Disk and restart your
computer.Then,follow the on-screen instructions to start your computer
from a floppy disk.
3......
The diagnostic tools were successfully loaded to drive c:
後來,到a:
我打format c:時
出現
Format not supported on drive c:
format terminated.
我試了最少有5-7次,都是這種情況...><
請問到底是怎麼了?~~~
謝謝 ^^
贊助商連結
(步驟是先按[y] , 1->1 , [y] )
用a:重新開機要準備format時,卻出現
Windows98 has detected that drive c does not contain a vaild
Fat or FAT32 partiton.There are several possible causes.
1.The drive may need to be partitioned. To create a partition on
the drive,run fdisk from the MS-DOS command prompt.
2.you may using third-parth disk-partitioning software.If you are using
this type of software, remove the Emergency Boot Disk and restart your
computer.Then,follow the on-screen instructions to start your computer
from a floppy disk.
3......
The diagnostic tools were successfully loaded to drive c:
後來,到a:
我打format c:時
出現
Format not supported on drive c:
format terminated.
我試了最少有5-7次,都是這種情況...><
請問到底是怎麼了?~~~
謝謝 ^^
贊助商連結