albert chung
2004-09-24, 10:36 PM
最近標了一台新的無線ATUR,家中使用環境為2M/256K,距機房3300公尺左右,2F兩台電腦,3F一台含ATUR,原有設備有642R51(bridge)、P312、BARSW4PHG、5PORT SWITCH,現在只用AWR-2440(pppoe)、5PORT SWITCH(無線功能關閉,使用原線路),使用上感覺3台電腦網頁開的比之前快,用NORTON線上掃瞄結果也與之前用P312時之結果一樣(設定都是預設),因為好奇拆開看了一下flash 4MB、SDRAM 16MB,無線模組好像是mini PCI介面,但是整台好熱喔,2天了還沒當機,上網查了一下規格如下供參考,
Specification:
* Chipset
- Texas Instruments ADSL Router Chip:(TNETD7300)
- RELTEK 4 Port Ethernet Switch :(RTL8305SC)
- Texas Instruments RF chipset : (TI) OPTION
* Line Connection
- RJ-11(2 wires) , RJ-45 (4 port) Connection
* ADSL Features
- DMT modulation and demodulation
- Tone detection for low power mode
ITU 992.1 (G.dmt) Annex A, B, C
ITU 992.2 (G.lite)
ITU 992.3 ADSL2 (G.dmt.bis)
ITU 992.4 ADSL2 (G.lite.bis)
ITU 992.5 ADSL2Plus
ANSI T1.413 Issue 2
* Full-rate adaptive modem
- Maximum downstream rate of 24 Mbps (ADSL2 )
- Maximum upstream rate of 1 Mbps
* G.lite adaptive modem
- Maximum downstream rate of 1.5 Mbps
- Maximum upstream rate of 512 Kbps
* WAN Mode Support
- PPP over ATM (RFC 2364)
- PPP over Ethernet (RFC 2516)
* LAN Mode Support
- Bridged/routed Ethernet over ATM (RFC 2684/1483)
- Classical IP over ATM (RFC 1577) and PPP over Ethernet
(RFC 2516)
* Bridge Mode Support
- Ethernet to ADSL self-learning Transparent Bridging
(IEEE 802.1D)
- Supports up to 128 MAC learning addresses
* Router Mode Support
- IP routing-RIPv2 (backward compatible with RIPv1)
- Static routing
- DHCP (Dynamic Host Configuration Protocol) Server and Client
- NAPT (Network Address and Port Translation)
- NAT (Network Address Translation)
- ICMP (Internet Control Message Protocol)
- Simultaneous USB and Ethernet operation
- IGMP
(Internet Group Management Protocol)
* 802.11g Wireless Access Point
- 54Mbps Access Point for wireless connectivity
- Interoperable with IEEE 802.11g
(PBCC & OFDM Modulation Technology supports) 2.4GHz
Compliant equipment
- Supports full mobility and seamless roaming from cell to cell
- Support Ad hoc and Infrastructure mode
- Support AP client architecture
- Support WEP (64/128 bit)Provides up to 30 users wireless connection
- Work range : per node indoors approximately 30m~100m,outdoors
(line of sight) 200m~300m
Depending on data rates
- External antenna : one 2dbi detachable antennas with diversity support
(Reverse SMA connector)
* Ethernet Features
- Four RJ-45 connectors for 10/100 Mbps Ethernet LAN connection,
DMZ function can be set up between them
- Complies with IEEE 802.3u specification
- Supports Auto-Negotiation
- Supports Auto-MDIX, Auto-MDI
- Supports IEEE 802.3x Flow control in Full Duplex mode
* PTT and Safety
- FCC Part 15, CE,
* Operating System
- Win 98SE/2000/ME/XP
* Power
- Input : 100~240V; 50/60Hz
- Output : 7.5VDC/1.5A
* LED Indication
- Power , ADSL LINK , WLAN , LAN PORT1~4
* Software Upgrade
- Upgrade by Ethernet Port
贊助商連結
Specification:
* Chipset
- Texas Instruments ADSL Router Chip:(TNETD7300)
- RELTEK 4 Port Ethernet Switch :(RTL8305SC)
- Texas Instruments RF chipset : (TI) OPTION
* Line Connection
- RJ-11(2 wires) , RJ-45 (4 port) Connection
* ADSL Features
- DMT modulation and demodulation
- Tone detection for low power mode
ITU 992.1 (G.dmt) Annex A, B, C
ITU 992.2 (G.lite)
ITU 992.3 ADSL2 (G.dmt.bis)
ITU 992.4 ADSL2 (G.lite.bis)
ITU 992.5 ADSL2Plus
ANSI T1.413 Issue 2
* Full-rate adaptive modem
- Maximum downstream rate of 24 Mbps (ADSL2 )
- Maximum upstream rate of 1 Mbps
* G.lite adaptive modem
- Maximum downstream rate of 1.5 Mbps
- Maximum upstream rate of 512 Kbps
* WAN Mode Support
- PPP over ATM (RFC 2364)
- PPP over Ethernet (RFC 2516)
* LAN Mode Support
- Bridged/routed Ethernet over ATM (RFC 2684/1483)
- Classical IP over ATM (RFC 1577) and PPP over Ethernet
(RFC 2516)
* Bridge Mode Support
- Ethernet to ADSL self-learning Transparent Bridging
(IEEE 802.1D)
- Supports up to 128 MAC learning addresses
* Router Mode Support
- IP routing-RIPv2 (backward compatible with RIPv1)
- Static routing
- DHCP (Dynamic Host Configuration Protocol) Server and Client
- NAPT (Network Address and Port Translation)
- NAT (Network Address Translation)
- ICMP (Internet Control Message Protocol)
- Simultaneous USB and Ethernet operation
- IGMP
(Internet Group Management Protocol)
* 802.11g Wireless Access Point
- 54Mbps Access Point for wireless connectivity
- Interoperable with IEEE 802.11g
(PBCC & OFDM Modulation Technology supports) 2.4GHz
Compliant equipment
- Supports full mobility and seamless roaming from cell to cell
- Support Ad hoc and Infrastructure mode
- Support AP client architecture
- Support WEP (64/128 bit)Provides up to 30 users wireless connection
- Work range : per node indoors approximately 30m~100m,outdoors
(line of sight) 200m~300m
Depending on data rates
- External antenna : one 2dbi detachable antennas with diversity support
(Reverse SMA connector)
* Ethernet Features
- Four RJ-45 connectors for 10/100 Mbps Ethernet LAN connection,
DMZ function can be set up between them
- Complies with IEEE 802.3u specification
- Supports Auto-Negotiation
- Supports Auto-MDIX, Auto-MDI
- Supports IEEE 802.3x Flow control in Full Duplex mode
* PTT and Safety
- FCC Part 15, CE,
* Operating System
- Win 98SE/2000/ME/XP
* Power
- Input : 100~240V; 50/60Hz
- Output : 7.5VDC/1.5A
* LED Indication
- Power , ADSL LINK , WLAN , LAN PORT1~4
* Software Upgrade
- Upgrade by Ethernet Port
贊助商連結